Air block cutting machine

　　As the core equipment in the process of aerated concrete production, the quality and cutting precision of the aerated block cutting machine directly affect the quality of the aerated block. The gas block cutting machine we produce has the characteristics of high efficiency, high cutting precision and high automation.

　　1. Model structure is simple and practical, easy to install and maintain;

　　2. After the body is turned upright, the body width is 600mm and the height is 1200mm, so the cutting steel wire is shorter, so it is not easy to break, not easy to drift, and the cutting precision is high;

　　3. The longitudinal cutting device is walking (the body is fixed on the cutting table) to complete the longitudinal cutting. Horizontal crosscutting device adopts screw drive to keep the same lifting drive of crosscutting frame
and ensure cutting accuracy;

　　4. The body walks, the air block cutting unit is fixed, and different cutting functions are completed through different equipment positions, so it can also assist the configuration of the corresponding notch processing or vacuum adsorption unit.

　　5. In addition to the production of blocks, this model can also produce plates, and the billet is cut on six sides, so the quality of the product is not affected by mold oil and mold deformation.

　　6. The cutting and turning table can be configured to turn over the blank after the cutting is completed, which is convenient to remove the waste on the bottom surface, and then turn back to the initial state.

　　7. Highly intelligent operation and management, using PLC centralized control, with frequency converter to achieve the entire cutting process automatic operation.

　　8. The operation of the equipment is simple and convenient, the cutting process (flipping, longitudinal cutting, transverse cutting) is completed in different stations, and the cutting and walking control are in differentdevices, because some work is simplified and the operation and maintenance are convenient.

　　After turning the mold over 90 degrees in the air, the blank body and the mold side plate are placed on the cutting car. The cutting car starts itself slowly through the starting longitudinal cutting device through the motor. After
the cutting car moves to the central position of the horizontal cross-cutting device to stop, the cross-cutting device starts, the cross-cutting frame drops vertically from top to bottom, and the horizontal cutting machine cuts until it
rises and resets.

Wait until updated